TECHNICAL DATA FOR READY-STRIP

Ready-Strip is, now 50% stronger, is a one of a kind, environmentally friendly, paint & varnish remover capable of removing up to 7+ layers in one application .The revolutionary "Colour Change" feature signals the time for paint removal. The stripper is applied to the surface & turns off-white or a pale green when the paint or varnish is READY to be removed. Ready Strip Plus is non - flammable, biodegradable, virtually odorless & can be cleaned up with water. It does not contain methylene chloride,caustic,flammable chemicals or harmful vapors like many traditional strippers.Ready-Strip avoids the uncertainty associated with other strippers that are ineffective if removed too soon, or dry out & not work if left to long.

Ready - Strip not only eliminates the guesswork, but will strip 3-4 times more paint & varnish.Unlike other strippers, Ready-Strip is a semi-paste & therefore truly clings to vertical surfaces.

2) Types of Paint Removed

Ready-Strip can remove most varieties of household paints&varnishes which are water or oil based including, latex,stains, enamels,lacquers,clear paints as well as polyurethanes etc.

3) Surfaces

Ready-Strip can be applied on a multitude of interior & exterior surfaces including wood,plaster,concrete, brick,stone,masonry,marble,metal & fiberglass etc.Ready Strip will not damage plaster or wood (discolour or raise the grain)or effect any surface it is used on.Ready-Strip is Not to be used on sheetrock,plastic,rubber,or linoleum surfaces.

4) Instructions

A) TEST PATCH

Since it is often hard to know the type or amount of paint or varnish on the surface, a small test area should be tested first to determine whether the desired results will be achieved.

B) Preparation

Mask any areas not being stripped with plastic & masking tape.

C) Application & Removel

Apply Ready-Strip liberally to the surface with a brush, medium sized nap paint roller, or putty Knife so that the remover completely "masks" or covers the colour of the surface to be stripped.Do not attempt to brush out too thin like a coat of paint.It covers approximately 50sq.ft per gallon. Apply at tempertures between 60F & 80F.When the stripper turns off-white or a pale green, it may form an eggshell like skin to lock in the stripping action.Misting the area to be removed with water or After-Strip Paint Remover Wash prior to actual removel will soften the skin & make lifting of the paint or varnish easier.After the stripper has turned off-white or pale green , use a stiff scraper to lift the paint from flat surfaces or a stiff bristle brush for detailed areas.After initial lifting, use a nylon bristle brush or stripping pad to scrub surface.The time the stripper takes to turn off-white or pae green may vary depending upon the type & amount of paint,the surface & temperture..Typical colour change usually occurs within 4-24 hours.Paint or varnish removel may take place prior to the "Colour Change" although the "Colour Change" will indicate the end of stripping action.Apply After-Strip Paint Remover Wash or light amounts of water for final clean up of residue.Surface should be completely dry before repainting.No need to neutralize ( acid wash) surface.Clean tools promptly after use with soap & water.

D) Removel Time

On interior surfaces , the softened paint / varnish may remain moist under the eggshell skin for several days for easy removal. On exterior surfaces, due to the potential for higher tempertures & direct sunlight, the "Colour Change" may be greatly accelerated ( 1-8hours).The paint should be removed shortly after "Colour Change " to prevent the stripper from drying out.Not advisable for outdoors decks.

E) Hints

If Ready-Strip is applied too thinly,left on too long or due to excessive heat conditions, the applied area is difficult to scrape, try the following:

1) Mist the applied area with water or After-Strip ,wait 5-15 minutes & remove.

2) Reapply Ready-Strip over itself, wait 15-30 minutes & remove.

3) If 1& 2 dont work scrape of & reapply.If product freezes in bucket,let thaw & stir vigorously until product is consistent.

5) Safty Instructions

Due to the sensitive nature of certain person`s skin, rubber gloves & safty glasses are recommened.Avoid eye contact.If eye contact occurs immediately flush with plenty of water for 15 minutes.Avoid prolonged & repeated contact with skin.If skin contact occurs, wash with soap & water.Maintain adequate ventilation especially in confined areas.If spraying is expected use NIOSH chemical cartridge (organic vapor )respirators.If swallowed do not induce vomiting.Give 1 or 2 glasses of water & call a physican immediately.

ALL PRICES INCLUDE GST!

Please Note: Prices are subject to change without notice!